This is easily done with a flat screwdriver. First we need to pop out the little plug that is right at the far end near the pedals. This is the panel that covers the fuse box. We don't need to take it all off, just pull it up until you can toss it over the top of the open door to keep it out of the way. Next we need to peel back some of the door's seal near the front of the car. Check the pictures, they explain it pretty well. :) Sometimes it's easier to start at one end and work your way along it. The first time you do this it may take a bit of extra effort, but it will come off eventually. Simply put your fingers under the inside edge of it, and give it a sharp pull upwards. This is the long piece of trim along the bottom of the doorway. In order to do that, we must first remove some of the car's trim around the driver's seat. ****** First we have to be able to access the entire fuse box inside the car by the pedals, not just the front with the fuses. This step is *exactly* the same as in the power window tutorial, but I will repost it here. For this mod, you will need a few extra pieces: - Wire cutter/stripper - Soldering iron + solder (if you want a more permanent setup) - 1-3 wire tap-in clamps, depending on what you choose to solder - Electrical tape Step 1: Remove the Car's Trim. This time, wires will be cut and reconnected, and we will add a fuse outside the car's fuse box. The concept for this mod is the same, but the process is different. In that mod, we simply connected the power windows to direct power from the battery instead of going through the ignition. This mod is not quite as easy as the power windows modification. That being said, this is a fairly easy process, with almost no risk involved, but you are solely responsible for anything that happens by following these instructions. I am not responsible for any damage caused, injuries incurred, or contracts violated by performing this modification. **DISCLAIMER** - At this point, I am sure any warranties on 2002 Proteges are no longer valid, however, you still do this modification at your own risk. I did not discover this on my own, all credit goes to Zap Wizard, however, I altered a few steps, and as it is not available on Instructables, I am posting it here. This mod shows you how to wire up the sunroof to operate at all times, just like the windows. If you already did the mod for your power windows, located here, then you may have noticed that it does not allow your sunroof to operate without the key in the ignition.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |